Crivit 338578 2001 Notice D'utilisation page 10

Congratulations!
You have chosen to purchase a high-quality pro-
duct. Familiarise yourself with the product before
using it for the first time.
Read the following instructions for
use carefully.
Use the product only as described and only
for the given areas of application. Store these
instructions for use carefully. When passing the
product on to third parties, please also hand
over all accompanying documents.
Package contents
1 x kids' Ice Skates
1 x hex key
1 x instructions for use
Technical data
Size: 33 - 37
DIN EN 15638:2009
Max. load capacity: 100kg
Date of manufacture (month/year):
07/2020
Intended use
This product was designed as a recreational
skate for private use, and is not intended for
competitive ice hockey or figure skating.
Safety information
WARNING!
Risk of drowning when skating on open
bodies of water.
Make sure that the ice is sturdy!
Risk of injury!
• Check the product for damage or wear, and
make sure that all connecting parts are firmly
attached, before each use. Only use the prod-
uct if it is in perfect condition!
• Do not modify the product in such a way that
it could potentially endanger your safety.
• For your own safety, always wear suitable
personal protective equipment (helmet, hand/
wrist/elbow/knee pads).
10 GB/IE
• Always wear reflective clothing so that you
are more easily visible.
• Risk of cutting! When working with the skates,
always remember that the blades are sharp!
• Do not use the product when barefoot.
Putting the skates on and
taking them off
Preparing for putting on the skates
in condition upon delivery
IMPORTANT!
Always make sure that your skates fit
properly. The outer boot should not
deform when the clasp is closed. Don't
close the clasp with force. If your outer
boot is deformed, this is either a sign
of incorrect tightness or you may have
purchased the product in the wrong
size.
Putting the product on:
• Put the skates on with the slip-on aids (1).
• Set the slider (3a) on the fastening clip (3) to
'Open'. Pull on the shoelaces (2) and set the
slider (3a) to 'Close' (Fig. D).
Important: make sure that the loose
shoelace ends do not hang out from the
shoe, as you could trip on them.
• Close the hook and loop fastener (7).
• Insert the ratchet strap (5) into the opening
under the rocking fastener (6) and tighten it
as needed.
Note:
By pushing the rocking fastener down,
you can move the ratchet strap back
and forth until you have found the right
tightness for your foot (Fig. C).
• Then close the safety clasp (4) ('CLICK').
Taking the product off:
• Open the safety clasp by pressing the but-
ton (4) (Fig. B).
• Press the rocking fastener (6) and pull the
ratchet strap out.
• Undo the hook and loop fastener (7).
• Set the slider (3a) on the fastening clip (3) to
'Open' to loosen the shoelaces (Fig. D).