DeWalt DWE46170 Guide D'utilisation page 4

4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use the correct power tool
for your application. The correct power tool will do the job
better and safer at the rate for which it was designed.
WARNING: The use of any accessory or attachment or
performance of any operation with this tool, other than those
recommended in this instruction manual may present a risk of
personal injury.
b) Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
c) Use the power tool, accessories and tool bits etc., in
accordance with these instructions taking into account
the working conditions and the work to be performed.
Use of the power tool for operations different from those
intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
Surface Grinding Shroud Safety Rules
• The shroud must be securely attached to the power tool
and positioned for maximum safety, so the least amount
of wheel is exposed towards the operator. The shroud is
designed to collect dust and help protect the operator from
accidental contact with the wheel.
• Do not use accessories which are not specifically designed
and recommended by the tool manufacturer. Just because
the accessory can be attached to your power tool, it does not
assure safe operation.
• Only use dry diamond surface cup wheels with this surface
grinding shroud. The surface grinding shroud is not intended
to be used with standard grinding, cut-off, cup wheels or wire
brushes.
• The rated speed of the accessory must be at least equal to
the maximum speed marked on the power tool. Accessories
running faster than their rated speed can break and fly apart.
• Hold power tool by insulated gripping surfaces only, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electrical shock.
• Always use side handle. Tighten the handle securely. The
side handle should always be used to maintain control of the tool
at all times.
• Do not use a damaged accessory. Before each use inspect
the accessory such as diamond wheel for chips and cracks,
backing pad for cracks and tear or excess wear. If power
tool or accessory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and installing
an accessory, position yourself and bystanders away from
the plane of the rotating accessory and run the power
tool at maximum no-load speed for one minute. Damaged
accessories will normally break apart during this test time.
• When starting the tool with a new or replacement wheel,
hold the tool in a well protected area and let it run for one
minute. If the wheel has an undetected crack or flaw, it should
burst in less than one minute. Never start the tool with a person in
line with the wheel. This includes the operator.
• Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing protectors, gloves
2