Télécharger Imprimer la page

Atag HG6111H Notice D'utilisation page 9

Publicité

Les langues disponibles

Les langues disponibles

Before using the appliance
The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
Only use the appliance if it has been built in
correctly. Damage to an incorrectly installed
appliance is excluded from the guarantee.
During repair the appliance needs to be
disconnected from the power supply
(electricity and gas). Remove the plug from
the wall socket or turn the switch in the
metre cupboard to zero (for gas hobs with a
spark switch). Turn off the gas tap in the
feeder pipe.
This cooking appliance is designed for
household use. It should only be used for
preparing meals.
When boiling and frying the hob gets hot.
Please pay close attention to small children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the kitchen.
This will produce a damp atmosphere.
When a gas cooking appliance is being used
heat and moisture is produced in the area
where the appliance is situated. Make sure
that the area is sufficiently ventilated; open
natural ventilation openings. When the hob is
used for longer periods extra ventilation may
be needed, such as an open window.
The burners should not be used without
pans. Never place aluminium or plastic trays
directly onto a burner.
Be careful with the cables of electrical
equipment, such as a mixer. These should
not be allowed to touch hot burners.
The underside of the built-in hob becomes
hot. Take care that you do not place any
flammable or plastic objects in any drawer
under the appliance.
Before installing the appliance, check that
the gas sort and gas pressure of the gas
source are in accordance with what is
specified on the model data plate.
Things to watch for
Clean immediately
Any spillage should be removed
immediately, particularly red cabbage, apple
sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners, give
rise to an irregular gas flame, or damage the
burner caps.
Burner cap
Burner ring
Spark plug
Burner casing
Injecter
Lighting the burners
While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can now be
smoothly adjusted from high to low.
Electrical spark switch
Press the desired control knob and turn it to
the left to the maximum setting. Keep the
control knob depressed until the burner
ignites.

Publicité

loading