SKF HMV Série Mode D'emploi page 11

Figure 9. Dial indicator and hydraulic pump.
Dial indicators (fig. 9a)
Calibrated in millimetres
Calibrated in inches
Hydraulic pumps with digital pressure gauge (fig. 9b)
0 - 100 MPa (0 - 15 000 psi)
Maximum nut size
Pump reference
Step by step mounting procedure
Step 1
Ensure that the bearing size is compatible with the HMV(C) E nut size. For example, for
bearing 23936 CCK/W33 mounted direct on a shaft, use HMV(C) 36E. Otherwise the
pressure corresponding to the starting position must be adjusted.
Step 2
Determine whether one or two surfaces slide during mounting. See figures 10 - 13.
Step 3
Drive the bearing up to the starting position by applying the correct hydraulic pressure to
the HMV(C) E nut. See figure 14.
As an alternative, the SKF digital pressure gauge can be screwed directly into the hydraulic
SKF HMV / HMVC
TMCD 10R / TMCD 5P
TMCD 1/2R
HMV (C) 54E HMV (C) 92E
729124 DU TMJL 100DU
HMV (C) 200E
TMJL 50DU
9