Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Problem
ELECTRIC MOTOR HAS
AN ODOR THE FIRST
FEW TIMES.
UNABLE TO START.
STOPS WHILE USING.
TOO MUCH PULP IN
THE JUICE.
ABNORMAL
VIBRATION OR LOUD
NOISE.
LOW QUANTITY OF
JUICE.
Cause Analysis
• WHEN USING THE JUICER FOR THE FIRST
TIME, ODOR MAY BE EMITTED.
• POWER PLUG IS NOT PLUGGED INTO
THE OUTLET.
• THE PULL ROD / SAFETY LATCH IS NOT
IN PLACE AND TOP COVER IS NOT
PROPERLY SECURED.
• LOW POWER VOLTAGE.
• EXCESSIVE INGREDIENTS PUSH THE ROD
WITH EXCESSIVE FORCE.
• MOTOR OVERHEAT CONTROL
PROTECTION.
• JUICE EXTRACTION SCREEN IS
DAMAGED.
• TOO MUCH PULP IN THE CENTRAL RING.
• IMPROPER INSTALLATION OF JUICE
EXTRACTION SCREEN.
• UNSTABLE PLACEMENT OF PRODUCT
OR CAME OFF OF FOOT PAD.
• EXCESSIVE INGREDIENTS.
• TO MUCH PULP IN FILTER BASKET.
• PUSHING PUSHER WITH EXCESSIVE
FORCE.
Solution
• IF THIS HAPPENS, ENSURE THERE IS
SUFFICIENT VENTILATION AROUND
THE APPLIANCE.
• MAKE SURE THE UNIT IS OFF AND
PLUGGED IN.
• TURN OFF THE UNIT, THEN UNPLUG
IT. REMOVE ANY INGREDIENTS IF
ALREADY ADDED. LIFT THE PULL
ROD / SAFETY LATCH GENTLY THEN
PRESS IT DOWN ENSURING TOP
COVER ASSEMBLY IS SECURELY
LOCKED IN PLACE.
• CHECK IF POWER IS OFF
• TURN OFF THE UNIT, THEN UNPLUG
IT. REMOVE ANY INGREDIENTS IF
ALREADY ADDED. LIFT THE PULL
ROD / SAFETY LATCH GENTLY THEN
PRESS IT DOWN ENSURING TOP
COVER ASSEMBLY IS SECURELY
LOCKED IN PLACE.
• RESTART IT AFTER STOPPING 20-30
MINUTES.
• REPLACE THE SCREEN.
• CLEAN THE CENTRAL RING.
• INSTALL JUICE EXTRACTION
SCREEN IN PROPER PLACE.
• PLACE PRODUCT STABLY OR
INSTALL THE FOOT PAD IN PROPER
PLACE.
• DISCONNECT POWER AND TAKE
OUT EXCESSIVE INGREDIENTS.
• CLEAN CENTRAL RING.
• PRESS THE PUSH ROD WITH LESS
FORCE.
10
Publicité
