Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Table continued from last page
Problem
Water remains in the
dishwasher.
Bad odour in dishwasher.
Grease deposits in the
dishwasher.
36
Possible causes
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs have
been selected for a prolonged
period.
Low temperature programs have
been selected for a prolonged
period.
Action
Clean the coarse and fine filters.
Check that the filter handle is
locked in the stop position. The
handle should point straight out
from the dishwasher.
Clean the drainage pump. See
the chapter Care and cleaning.
Check that the coloured stop on
the right in the bottom drain is in
place. See the chapter Care and
cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high
temperature once or twice a
month. Or run a self-cleaning
program. See Self-cleaning in
the chapter Using the
dishwasher.
Select a program with Intensive
mode. The program will use a
higher temperature to dissolve
grease on very dirty dishes. Or
run a self-cleaning program
once or twice a month. See
Self-cleaning in the chapter
Using the dishwasher.
Publicité
