Ryobi RY803223 Manuel D'utilisation page 11

 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Pressure Washer
35 ft. High Pressure Hose
Handle
Spray Wand
5-in-1 Change-over Nozzle
Storage Panel
Screws (4)
Nuts (4)
Wheels (2)
Axles (2)
Hitch Pins (2)
Washers (2)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Disposable Funnel
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ASSEMBLY
TOOLS NEEDED
See Figure 2.
The following tools (not included or drawn to scale) are
needed for assembly:
 Phillips Screwdriver
 10 mm Wrench
INSTALLING THE WHEELS
See Figure 3.
 Locate the axles, hitch pins, washers, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 4.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Push and hold the button on the handle frame as you slide
the handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in place.
INSTALLING THE STORAGE PANEL AND
TRIGGER HANDLE HOLDER
See Figure 5.
 Align the holes in the storage panel with the holes in the
handle, as shown.
 Insert screws through the left holes (when viewed from
front). Install nuts and tighten securely using a Phillips
screwdriver and 10 mm wrench (not provided).
7 — English