Fill Level Indicator; Control Of Substances Hazardous To Health (Coshh); Water Flow Adjustment; Important - Numatic TT 516B Notice Originale

Fill Level Indicator

Fill the clean water tank to a maximum of 18 litres, including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
12
Use the fill indicator
(Fig 12).
Always ensure that chemical manufacturer's safety guidelines are followed.

Control of Substances Hazardous to Health (COSHH)

For best results use a non-foaming type of chemical, dilute to the manufacturer's specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/

Water Flow Adjustment

14
Pre-cleaning advice.
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor (Fig 16).
Numatic part (629044) Wet Floor sign
(available if required)
!
Do not operate machine unless the Operator Manual has been read and fully understood.
Machine Set-Up
13
Showing the clean water tank empty
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
for UK information.
15
(Fig 13).
Located on the left of the machine is the On / Off water tap
(Fig 14 / 15).

Important

10
13a
Showing the clean water tank full
(Fig 13a).
16
!
!