Publicité
Les langues disponibles
Les langues disponibles
PREPARING THE TOOL
Read the section titled Important Safety Instructions for
Pneumatic Tools at the beginning of this manual. Always wear eye and ear
protection when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures and checks
before each use of the nailer.
To reduce the risk of damage to the tool, only use a non-detergent SAE
20 weight oil.
1.
Before you use the nailer, be sure that the compressor tanks have been
properly drained.
2.
Lubricate tool:
a.
To reduce the risk of damage to the tool, only use a non-detergent SAE 20
weight oil.
b.
Use a filter when possible.
c.
Add 5 to 7 drops of oil in the air fitting a least twice a day.
3.
Always wear eye and ear protection.
4.
Ensure canister is empty of all fasteners.
5.
Check for smooth and proper operation of contact trip. Do not use tool if
assembly is not functioning properly. NEVER tamper with the contact trip.
NEVER use a tool that has the contact trip restrained in the actuated position.
6.
Check air supply: Ensure air pressure does not exceed recommended
operating limits; 70 to 120 psi, (4.9 to 8.3 bar, 5 to 8.5 kg/cm
7.
Keep tool pointed away from yourself and others.
8.
Connect air hose.
9.
Check for audible leaks around valves and gaskets. Never use a tool that leaks
or has damaged parts.
To reduce the risk of personal injury, always disconnect tool
from air supply before performing maintenance, clearing a jammed
fastener, leaving work area, moving tool to another location or handing
the tool to another person.
LOADING THE TOOL (FIG. 1–6)
Keep the tool pointed away from yourself and others. Serious
personal injury may result.
Never load nails with the contact trip or trigger activated. Personal
injury may result.
Read all Safety Warnings before
1.
using tool.
2.
Connect the air supply to the tool.
3.
Lift the canister door latch (E) to open
the nail guide door (H).
4.
Rotate the canister door (I) open.
5.
Adjust the nail platform (J) to properly
accommodate the nail length being
used. Pull the nail platform (J) up or
down for desired nail.
OPERATION
Fig. 2
E
8 - ENG
).
2
H
I
Publicité
