Commissioning; Filling The Tank; Removal From Service - Reflex Storatherm Aqua Inox AI 150/1M Mode D'emploi

Commissioning

6 Commissioning
The responsible installer must explain to the operator how the tank functions and how it is to be used. He/She must draw attention to
maintenance work that has to be carried out at regular intervals. The service life and correct functioning of the tank are dependent on
this. The tank must be emptied if there is a risk of frost, or prior to its being removed from service.
6.1

Filling the tank

Proceed as follows when filling the tank:
1. Prior to first filling, rinse the tank and pipes with water.
– Dispose of the water into the collection tray, see chapter 5.2 "Installation location" on page 17 .
2. Fill the tank with water until bubble-free water escapes from the open hot water drawing point.
3. Check the connecting fittings for leaks.
– If necessary, tighten the connecting fittings.
Note!
During the heating phase, water escapes at the safety valve due to expansion of the water.
• Do not close the safety valve.
7

Removal from service

Remove the tank from service when requested to do so in the heating appliance operating manual, see chapter 8.1 "Draining" on
page 21.
Note!
Empty the tank when removing from service.
• If there is a risk of frost.
• During maintenance.
20 — English Storatherm — 19.03.2018