Publicité
Les langues disponibles
Les langues disponibles
6
TEST INSTALLED FAUCET & CHECK CONNECTION FOR LEAKS
• Move HANDLE (1) into "off" position.
• Turn on water supplies and check connections for leaks.
• With HANDLE (1) in "off" position, unthread SPRAY (3)
from HOSE (2).
• Operate HANDLE (2) up and down, left and right to flush
water lines thoroughly.
• Replace SPRAY (3) onto HOSE (2).
• Operate HAND SPRAY and check connections for leaks.
7
FAUCET OPERATION – AUTOMATIC MODE, MANUAL MODE AND FEATURES
Automatic Mode
• Make sure the SLIDING DOOR (1) and HANDLE (2) are in the open position.
• To turn on the water, momentarily place your hand within 3" of the
SENSOR (3).
• To turn off the water, momentarily place your hand again within 3" of the
SENSOR (3).
Manual Mode
• Close the SLIDING DOOR (1) and use the HANDLE (2) to turn on and off
the water.
FEATURES
Safety Timer
• The faucet will automatically turn off the water after 5 minutes of
continuous use. Momentarily place you hand in front of the sensor to
turn on the water.
Low Battery Indication
• The sensor will start to blink constantly every second. This is the indication
that the batteries are low in power. Replace the batteries with Qty. (4) AA
Alkaline type batteries.
• Battery lifetime is approximately 1 year under normal use.
3
REMOVE
CHECK
CONNECTIONS
FOR LEAKS
OPEN
CLOSED
- 4 -
1
1
3
Closed
Hot
Cold
Open
2
M965802 Rev.1.2 (11/18)
Publicité
