KRATOS SAFETY FA 60 022 03 Guide D'installation Et D'utilisation page 5

INSTALLATION OF THE ADAPTATION KIT (
SYSTEM WITH BUILT-IN RESCUE WINCH ON MULTISAFEWAY:
Once the MultiSafeWay has been installed,
1) Place the adaptation plate (ref. FA 60 022 04 for 20 m / ref. FA 60 022 03 for 30 m / ref. FA 60 022 05 for 10 m) on the body of the jib where
the 2 holes for this purpose are located:
2) Attach it using 2 ball indexing pins that slide into the adjustment holes on the jib body (Fig. 1).
The black screw should be in the lower part of the plate.
Fig. 1
INSTALLATION OF THE RETRACTABLE FALL ARRESTER WITH INTEGRATED RESCUE WINCH:
1) Unscrew the black screw from the plate.
2) Take the retractable fall arrester (FA 20 401 10/S, FA 20 401 20/R/S, FA 20 401 30/S) and put it upside down (the wire rope exit should be
towards the top).
3) Slide the metal part of the axis of the fall arrester in the gap of the plate (Fig. 2).
4) Put the black screw in the anchor ring of the fall arrester and screw it back (Fig. 3).
Fig. 2
5) Before use, make sure that the device is in Fall arrest mode (see point 1 of the « Use in Fall arrest mode » section).
6) Remove the safety pin and lift the cover, unroll the cable up to the return pulley located on the jib arm and pass the cable through the pulley.
Continue to unroll the cable until it reaches the end pulley. Lift the cover and carefully thread the cable through the end pulley. Close the cover
and insert the safety pin (Fig. 5).
Fig. 4
FA 60 022 03 / FA 60 022 04 / FA 60 022 05
The handle of the fall arrester should be folded up before each use.
5
) FOR FALL ARREST
Fig. 3
Fig. 5
GB