Channel Search - Zodiac DZR-3000FTA Manuel D'utilisation

ENGLISH

4.2 Channel Search

1. Antenna: Select your antenna number.
2. Satellite: Select desired satellite using keys. Pressing the OK key will also' display a list of satellites. You
can see the information on the selected satellite on the right side.
Edit Mode: If you want to edit certain preprogrammed data such as Transponder, Frequency, Symbol Rate,
Polarizaion and 22 KHz, press Edit mode key (Red color key) on the RCU.
3. Position: After selecting a seatellite, please select position button and then keep pressing E or W key on the
RCU until the selected satellite is locked. If the satellite is locked correctly, the color of the signal label bar will
change to yellow.
When you press OK key on the RCU, the message "Would you to set the value of courrent positioner?" will be
displayed.
4. Transponder: Select desired transponder using LEFT/RIGHT Pressing the OK key will display a Down List
box which also lets you select the desired transponder.
5. Frequency & Symbol Rate: Edit the Frequency and Symbol Rate.
6. Polarization: Select Hor or Ver.
7. 22KHz: Select ON or OFF
8. Antenna Setup: Press ok can enter Antenna Setup menu.
Search 1 Sat: Allows you to search channels using the arrows keys.
Search 1 STA:: Search channel for one satellite, which has been selectd from the Satellite column.
Search TP: Search channel in one TP, which has been selected from the TP column.
Search Network: Search channels for the network related to the TP.
Search all SAT: Search all channels at once on all satellites. DZR will automatically search channels for TV
and Radio. During this procedure you can see a list of the previously searched channels in the Searched List
Box on the screen. On completion of searching channel, the cursor will be placed on COMPLETE auomatically.
Now press OK button.
10. Set PID: If you want to set PID (Packet Identifier) manually, select TP in the "Channel Search Page" and
press MENU key on the RCU to display the command box.
Then select SET PID command and press OK. The set PID menu will be displayed. Enter the correct value and
select OK.
11. Sat name edit: If you want to change the satellite name, select the satellite and press Sat Name Edit key
(Yellow color key) on the RCU to display the command box. The keypad dialog will appear. Using the arrow
keys on the RCU, you can edit the satellite name.
12. Delete TP: If you want to delete a Transponder, please select the Transponder which you want to delete
and then press MENU key on the RCU to display the command box. Then select Delete TP command. A
confirm message box will be displayed.
13. Re-Sync: When all the locations of searched satellites are shifted for any reason, you can realign all of
them once you adjusted one satellite location.
14. Search Option: DZR allows you to search channels with convenient options as shown below.
a. FTA Only
b. Not searched TP only
c. Sort by Scramble
If you select Sort by Scramble, DZR sorts the scrambled channels automatically. If you select Not searched TP
only, DZR searches channels in the TP which were not searched.
E - 5