Automatic Tape Selection; Playback - Denon DRM-555 Mode D'emploi

ENGLISH

AUTOMATIC TAPE SELECTION

This Stereo Cassette Deck contains an automatic tape selector which
automatically selects the optimum bias and equalization for the tape in use.
This is accomplished by detection of the tape type detections holes in the
cassette housing.

PLAYBACK

• Switch on your amplifier or receiver.
• Set the Tape Monitor switch on your amplifier or receiver to the TAPE position.
• The numbers in the illustration below depict the order in which operation steps are carried out.
EJECT
5
T MER
REC OFF PLAY
¢ON £OFF
q Press the Power Operation switch to the
w Press the Eject button (EJECT
cover.
e Load the cassette tape and close the cassette compartment cover.
r When listening to a tape that has been recorded with Dolby noise
reduction, set the Dolby NR switch (DOLBY NR) to match the system used
at the time of recording.
8
DRM 555
PREC S ON AUDIO COMPONENT/CASSETTE TAPE DECK
AUTO REVERSE
¢
ON position.
5
) to open the cassette compartment
DOLBY NR
B OFF C
• If a tape without tape type detection holes is used, the deck will be set
for normal tapes.
dB -40 -30 -20 -10 5 3 -1 0 +1 +3 +5 +10
L
R
‚¤‚‚
REMOTE SENSOR
2 STOP 3 REC PAUSE
PLAY PHONES
D RECTION REC/REC MUTE
CD SYNCHRO REC
t Press the Direction button (
Transport Direction
Forward
Reverse
Detection holes
for metal tape
Detection holes for
chrome tape
NPUT LEVEL
5
RESET
COUNTER
MEMORY
MPX
REV MODE
DOLBY NR
B OFF C
PHONE LEVEL B AS F NE BALANCE
+
MIN MAX LEFT RIGHT
0 1
) to select the direction of tape transport.
Indicator