Agilent Technologies Turbo-V 551 Rack Notice De Mode D'emploi page 225

17
Technical Information
Connection J1 Remote I/O Interconnections
Controller-to-Pump Connection
A five-meter long cable is provided to connect the controller to the
pump. The following figures show the pump connector configuration
where pins:
A-F = upper bearing sensor
B-C-D = 3-phase output to pump motor
E = ground
A-G =pump body temperature sensor
Figure 16 Pump connector
The pump cable can be extended by means of an optional extension
cable (see Orderable Parts table).
Turbo-V 551 Rack Controller User Manual / 87-901-031-01 (A) 225/288