Pioneer PDP-5080XD Mode D'emploi page 37

Setting up
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Power Management" (/ then ENTER).
4 Select "Mode 1" or "Mode 2" (/ then ENTER).
Item Description
Off (default) No power management
Mode 1 • Places the system into the standby mode when
no signal is received from the personal computer
for eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
Mode 2
• Places the system into the standby mode when
no signal is received from the personal computer
for eight seconds.
• When you start using the computer and a signal
is input again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
5 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
08
37
En