Publicité
Les langues disponibles
Les langues disponibles
11.3
Cleaning
▪
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
▪
The tool should be thoroughly cleaned both before and after use.
▪
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could at-tack the plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of water into an electric tool increases the risk
of an electric shock.
Important! Never clean the tool under running water - and particularly never
with high pressure - because of the potential danger to persons and property.
11.4
Storage
▪
Store the machine in a secure dry and frost-proof place out of reach of children.
▪
Do not place other objects on top of the machine.
11.5
Service department
▪
If the machine should happen to fail despite the care taken in manufacturing and testing,
repair should be carried out by our technical department.
▪
Damaged parts must be replaced by our after-sales service department.
12 TECHNICAL DATA
Type
Voltage
Cutting width grass shear
Cutting length shrub shear
Knife distance grass shear
Knife distance shrub shear
No load speed
Telescopic length
13 NOISE
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
The vibration emission during actual use of power tool can differ from the
declared total value depending on the ways in which the tool is used.
The safety measures to protect the operator are identified based on an
estimation of exposure in the actual conditions of use.
Copyright © 2024 VARO
POWDPG75300
POWDPG75300
20 V
100 mm
185 mm
10 mm
7.5 mm
-1
1100 min
630 mm – 920 mm
P a g e
| 11
EN
www.varo.com
Publicité
