Henco LOGIC Mode D'emploi page 9

| | |
Deutsch Français Nederlands English
Remark: in cooling mode, Anti-freeze mode
acts like the OFF mode (system is stopped).
If "floor limit" regulation is set by user/ installer,
selecting anti-freeze mode stops "floor limit
regulation".
Antifreeze temperature setpoint is applied
when opened window is detected.
5.1.5 OFF mode
Use this mode if you need to switch off your
installation.
Be Careful: In this mode your installation can
freeze.
- With off mode, "floor limit" regulation is
stopped.
5.1.6 Reversible mode
This mode allow to switch between the heat-
ing and cooling system, the changeover can
be managed by the thermostat in Master
mode (manual or automatic) displayed in Slave
mode (H&C signal at the thermostat input).
9