Publicité
Les langues disponibles
Les langues disponibles
|
|
|
Deutsch
Français
Nederlands
English
7.2 User parameter description
ECO/Reduced offset setting
Default value: 2.0°C
Values: 0.0°C to 5.0°C
"basic navigation" mode
"Yes": Activation of function, restrict to comfort and off mode.
"no": No activation
Default value: no
Values: Yes / no
Room temperature display
"Yes": remote displays measured temperature
"no":
remote displays set point temperature
Default value: Yes
Values: Yes / no
Calibration of internal room sensor (remote)
This menu is only displayed if parameter rEG (#20) is set with "Air"
or "Fll".
Calibration must be done after a given order has been operating
for a day. Place the thermometer in the middle of the room at
about 1.5 m above the floor. Record the temperature shown after
1 hour. When you enter calibration mode, displaying of
logo
means no calibration has been performed yet. Enter the reading on
your thermometer using minus
and plus
keys (step of 0.1°C).
The setting is validated with validation
key.
logo appears to
indicate that calibration.
If user press simultaneously minus
and plus
keys, sensor
calibration is reset.
logo disappears.
Important note: a large temperature deviation may indicate an
inappropriate installation of the thermostat. If the temperature
difference is too big, this could mean your thermostat was not
installed properly e.g. in the right place.
Default value: 0.0°C
Range value: -5.0°C and 5.0°C
13
Publicité
