Publicité
Les langues disponibles
Les langues disponibles
REATTACHING THE REFRIGERATOR DOORS
4. Connect the water line (
on the coupler with pulling tube. Connect the one
connector (
) on left side door, the other connector
4
(
) on right side door and two connectors (
7
each side of the top cap.
The clip is enveloped inside of the top cap.
5
• The Water Line must be fully inserted to the
center of transparent coupler (Type A) or the
CAUTION
line (Type B) to prevent water leakage from the
dispenser.
• Insert the clip in the install pack and check that
it holds the line firmly.
5. Position the top table (
the 3 screws into the top table with a philips screw
driver(+). After door opened, reinsert the cap top table
(
) and close the doors.
1
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is tilted.
If you see one of them, please refer to "Adjusting the
doors" page on 15.
DA68-01827C-16.indb 13
) and then insert a clip
5
) at
3
) in place. Insert and tighten
2
3
4
Type A
Type B
Dispenser
Center of Transparent coupler
clip A (1/4")
(6.35mm)
1
3
7
The Guide Lines
clip A (1/4")
(6.35mm)
2
Setting Up _13
2013. 12. 10.
5:00
Publicité
