Assembly - HOLZMANN MASCHINEN VD 1100ECO Mode D'emploi

14.3

Assembly

 Prepare parts and install the stand as shown in below pictures.
 Position the head stock over the top plate and align
the holes in the bed with the holes in the tope plate.
Set the lathe on the stand by tightening the bolts.
 Insert stud bolt into the mount holes in cutter mount
and 3-way milling, then tighten nuts on two sides.
 Screw cranks and fix the hub
 The leg set must be fastened to the supporting surface!
 Do not operate your wood lathe until it is completely assemble and adjusted
according to the instruction!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
ASSEMBLY
25
VD 1100ECO