Publicité
Connecting to the speaker system
CAUTION
The input terminals of speaker systems have a negative (–) pole and a positive (+) pole. Make sure to align these poles
'
correctly when connecting to the speaker terminals of the TAD-M600.
Make sure to use speakers with an impedance of 4
'
Use speaker cables with a large electrical capacity and make sure no warps or shorts are present. Using speaker cables
'
with a small electrical capacity or making imperfect connections could affect the sound quality of your speakers or cause
abnormal heating and shortage.
Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare
'
speaker wire touches the back panel it may cause the power to cut off as a safety measure.
These speaker terminals carry
'
disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts.
How to connect the speaker system
Connect the positive (+) terminal of the speaker system to the positive (+) terminal of the TAD-M600.
Connect the negative (–) terminal of the speaker system to the negative (–) terminal of the TAD-M600.
Connecting the speaker cable
1.
Remove 15 mm of the protective insulation to the speaker cable, and twist the core wires together.
2.
Turn the speaker terminal knob to the left. (
The terminal knob will slide out and create a gap.
3.
Insert the speaker wire into the gap and turn the terminal knob to the right to tighten. (
1
15 mm
Y lug terminals may also be connected (refer to your plug's operation
manual for further information).
All manuals and user guides at all-guides.com
Ω to 16 Ω.
HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or
)
2
Speaker terminal
Terminal knob
)
3
Speaker cable
Y lug terminal
TAD-M600
11
Publicité
