Furrion FMSM09AB-BL Manuel D'instructions page 9

Standard trim kit installation
1. Take out microwave oven and component(s) from the box and put on a flat surface (Fig. 7).
Fig. 8 - M4 x 1/2" - Screws x 4 Fig. 8 - M4 x 1/2" - Screws x 4
2. Attach the left and right metal brackets to the microwave oven with 4 - M4 x 1/2" screws provided (Fig. 8).
3. Slide the microwave oven into the cabinet opening (Fig. 9).
Fig. 10 - M4 x 13/16" - Screws x 4 Fig. 10 - M4 x 13/16" - Screws x 4
4. Attach the microwave to the cabinet with 4 - M4 x 13/16" screws provided (Fig. 10).
5. Assemble the trim kit as shown in Fig. 11. (NOTE: DO NOT assemble reversed).
6. Install the assembled trim kit over the microwave oven and push until it snaps into place (Fig. 12).
Electrical Connection
Connect the microwave oven to a 120 volt, 60 Hz, AC only, 15 amp or 20 amp dedicated circuit. It is recommended that
an individual circuit serving only the microwave oven be provided.
Metal Bracket x 2
Short Strip x 2
Long Strip x 2
Fig. 7 Fig. 7
Fig. 12 Fig. 12
- 8 -
M4 x 5/8"
Screws x 4
M4 x 13/16"
Screws x 4
Fig. 9 Fig. 9
Fig. 11 Fig. 11
CCD-0008963 Rev: 07-02-24