Publicité
Les langues disponibles
Les langues disponibles
Before Installation
1. Make sure that all the packing materials are removed from the oven cavity.
2. Check the oven for any damage, such has misaligned or bent door, damaged door seals and sealing surface, broken or
loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the
oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest food likely to be
cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustible materials.
5. The oven must have sufficient airflow. Do not cover or block any openings on the oven. Do not remove feet on which
oven stands.
6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
7. Make sure that the power supply cord is in good condition and does not run under the oven or over any hot or sharp
surface.
8. The electrical outlet or circuit breaker must be accessible to disconnect power in an emergency.
Microwave Oven Installation
Cabinet preparation
1. Select a suitable place that is not susceptible to moisture.
2. Mark and cut out and opening in the cabinet according to the dimensions outlined in the table (Fig. 1).
NOTE: If a range hood is installed under the microwave oven, 1" minimum clearance must be reserved
from the bottom of the microwave oven to the top of the range hood. Refer to Dimension E.
A
13 3/8" (339.7mm) Minimum
to
13 7/8" (352.4mm) Maximum
Fig. 1
Fig. 1
Dimensions
B
19 15/16" (506.4mm) Minimum
to
20 1/4" (514.3mm) Maximum
C
Minimum
13 15/16"
(354mm)
- 6 -
D
Minimum
Minimum
1/2"
(12.7mm)
(25.4mm)
CCD-0008963 Rev: 07-02-24
E
1"
Publicité
