Publicité
Les langues disponibles
Les langues disponibles
(3) Adjusting the tightening torque (See Fig. 9)
Rotate the clutch dial and line up the numbers "1, 3,
5, ... 22" on the clutch dial, or the dot, with the triangle
mark on the outer body. Adjust the clutch dial in the
weak or the strong torque direction according to the
torque you need.
CAUTION
● The motor rotation may be locked to cease while
the unit is used as drill. While operating the
driver drill, take care not to lock the motor.
● When setting the shift knob to "HIGH" (high
speed) and the position of the clutch dial is "17"
to "22", it may happen that the clutch does not
engaged and that the motor is locked. In such
a case, please set the shift knob to "LOW" (low
speed).
● If the motor is locked, immediately turn the
power off . If the motor is locked for a while, the
motor or battery may be burnt.
● Too long hammering may cause the screw
broken due to excessive tightening.
● A buzzing noise is produced when the motor
is about to rotate; This is only a noise, not a
machine failure.
7. Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 11).
Light
CAUTION
Do not look directly into the light. Such actions
could result in eye injury.
Switch
trigger
Fig. 11
8. Using the hook (sold separately)
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When carrying the power tool with hooked to
your waist belt, do not fi t any bit to the tip of
power tool. If the sharp bit such as drill is fi tted
to the power tool when carrying it with hooked to
your waist belt, you will be injured.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Placing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 12)
Hook
(2) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 13)
English
Groove
Screw
Fig. 12
Screw
Hook
Fig. 13
15
Publicité
