Domo DO990TDK Mode D'emploi page 40

adjustable legs can be adjusting by screwing them in or out of the
appliance.
· Avoid direct sunlight and heat. Direct sunlight may affect the
acrylic coating. Heat sources nearby will cause higher electricity
consumption.
· Avoid very moist places. Too much moisture in the air will cause frost
to from very quickly on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that
the voltage stated on the rating label of your appliance corresponds
to the voltage in your home. A different voltage could damage the
appliance.
· The appliance must be grounded. The manufacturer is not responsible
for damages that may occur as a result of usage without grounding.
· After installation, leave the freezer for 24 hours before turning it on.
This way the refrigerant can settle.
· Allow the appliance to run empty for 12 hours so the compartment
can cool to the appropriate temperature.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.
· The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can find the climate class on the type plate on the back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty. It is recommended that two people carry out the works.
1. Remove the upper hinge cover plates.
2. Remove the screws from the top hinge with a Phillips screwdriver.
40
DO990TDK
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Keep enough space of door open.
Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
1007
902 mm
1007
13
13
1052 mm
1071