Würth 0702 520 Traduction Des Instructions De Service D'origine page 21

Malfunction
Overload protection:
The load speed drops
SHARPLY.
Overload protection:
The load speed drops
SLIGHTLY.
S-automatic safety
cut-out: The machine
was SWITCHED OFF
automatically.
Restart protection: Machine
not running.
Cleaning and maintenance
Important!
The device may only be cleaned with
the mains plug disconnected.
The dust mask or respirator must be
capable of filtering particles generated
by your operation.
Motor cleaning
Clean the machine at regular intervals,
frequently and thoroughly by blowing
compressed air through the rear
ventilation slots. Here, the machine
must be held firmly.
Troubleshooting
Possible cause
The motor temperature is too
high!
The machine is being
overloaded.
The machine is switched off in
the event of an excessive current
increase rate (such as can occur
e.g. in the event of sudden jam-
ming or a recoil).
The restart protection device has
tripped.
Remedy
Allow the machine to run at idle speed until it has
cooled down.
Continue to work with a reduced load.
Switch off the machine at the
Then switch on again and continue to work normally.
Avoid further jamming. See chapter Recoil and the
associated safety precautions.
If the mains plug is inserted with the machine switched
on, or if the power supply is restored after an interrup-
tion, the machine does not start. Switch the machine off
and on again.
Accessories
Use only original Würth accessories.
Use only accessories satisfying the requirements and
technical data given in this operating manual.
Attach accessories securely. If the machine is oper-
ated in a clamp: Mount the machine securely. The
loss of control can result in injuries.
A Collets
Ø 3 mm = Item XX
Ø 1/8" = Item XX
Ø 6 mm = Item XX
Ø 1/4" = Item XX
Ø 8 mm = Item XX
B Mounting block Item XX For clamping the
power tool when working with flexible shafts
(tighten clamping screw), plus:
C Clamp Item XX For secure attachment to the
workbench (tighten clamping screw).
D Chargers: Item XX, Item XX etc.
ON/OFF switch [5]
.
21