Behringer CHROMATIC TUNER TU300 Manuel D'utilisation page 12

12 CHROMATIC TUNER TU300
Thank you for showing your confidence in us by purchasing the
Behringer CHROMATIC TUNER TU300. This compact guitar and bass tuner
provides 7 different tuning modes. Thanks to its 7-segment LED display
and 11-point LED indicators, it provides great visibility, especially in
dark environments.
1. Controls
The ON/BATT LED illuminates when the tuner is activated. It also
(1)
serves as a battery level indicator.
This LED meter indicates to what degree the instrument's tone
(2)
deviates from the reference tone.
These yellow arrow LEDs light up when the played note is below or
(3)
above pitch. Both LEDs will light up when the tone's pitch is correct.
The 7-segment LED display indicates the string number (high E
(4)
string: "1", B string: "2" etc.) of the strummed string of your
instrument, if the TU300 is operated in one of the guitar or bass
modes. In chromatic mode it displays the note name. Semitones
are shown by the decimal point LED ("#") in the display.
Press the STREAM/CENT button to switch between the LED
(5)
display modes.
Press the MODE button to select the tuning mode.
(6)
Use the footswitch to activate/deactivate the tuner.
(7)
Connect your guitar or bass to the ¼" TS IN connector.
(8)
Connect your amp or another stompbox to the ¼" TS OUT
(9)
connector. When the tuner is activated (footswitch pressed)
the output is muted. This way, you can silently tune your guitar
or bass.
The ¼" TS BYPASS connector always sends a signal to your amp
(10)
independently of the footswitch position.
Use the DC IN connection at the right side of the unit to plug in a 9 V
power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.nd remove the
pedal cover. Be careful not to scratch the unit.
◊ ◊
The TU300 is powered as soon as you insert a plug into
the INPUT. The battery is "disconnected" when the plug is
removed. For this reason, the TU300 has no on/off switch.
To extend battery life, always disconnect the input when
the unit is not in use.
The SERIAL NUMBER is located at the bottom.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.