Télécharger Imprimer la page

Parkside 385631 2107 Traduction Des Instructions D'origine page 13

Publicité

Les langues disponibles

Les langues disponibles

3. Check that the keyless chuck (17)
is securely locked by pulling on it.
The keyless chuck with SDS Plus
adapter exhibits some radial play
for technical reasons.
4. Rotate the keyless chuck (17)
counter-clockwise, until the drill
chuck aperture is large enough to
accommodate the tool.
5. Push the tool as far as possible
into the keyless chuck (17).
6. Rotate the chuck clockwise to
clamp the tool firmly.
Removing tools with hexa-
gonal and cylindrical shafts
1. To remove the tool again, rotate the key-
less chuck (17) and pull out the tool.
Removing the keyless
chuck
1
Pull the locking sleeve (3) backwards
and remove the keyless chuck.
Operation
Selecting the operating mode
The "drilling/impact drilling" changeover
switch (
4) allows you to select the elect-
rical tool operating mode.
Only change the operating mode
when the electrical tool is switched
on! The electrical tool may be da-
maged otherwise.
The "impact drilling" opera-
ting mode may only be used
if the keyless chuck is not at-
tached!
Unlock the changeover switch (
pushing the retaining knob (
Turn the "drilling/impact drilling" changeo-
ver switch (
4) into the desired position.
The retaining knob (
into place once the final position has been
reached.
Impact drilling =
striking mechanism ON
Drilling/screwing =
striking mechanism OFF
Set the direction of rotation
You can select the direction of rotation
with the direction switch (
and anticlockwise direction) and secure
the device against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (7)
to the right.
3. Anticlockwise direction:
Press direction switch (7)
to the left.
4. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.
Switching on/off
By using the on/off switch (
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
1. Press and hold the on/off switch (8)
to start the device. The LED work light
(11) lights up during operation.
IE
4) by
5).
5) will audibly lock
7) (clockwise
8) you can
13

Publicité

loading

Ce manuel est également adapté pour:

Pbha 12 a1