SilverCrest SMK 1000 A1 Mode D'emploi page 27

Low liquid level control
The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug .
Cleaning and Care
Ideally, you should clean the appliance immediate-
ly after use. Dried food residue is more difficult to
remove.
DANGER –
RISK OF ELECTRICAL SHOCK!
► Ensure that no moisture can get into/onto the
built-in plug and the safety socket
the blender jug
► Ensure that no moisture can get into/onto
the contact plug
jug !
Never immerse the lid
liquids! Otherwise there is a risk of an
electric shock.
WARNING! RISK OF INJURY!
► Take care when cleaning the lid
attached blades
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug
2) Place the lid on the blender jug
that the contact plug
rectly in the safety socket
3) Insert the connector
on the appliance.
4) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
5) Press the MODE button
BLEND programme indicator
flash.
6) Press and hold the START/STOP button
allow the appliance to run for about 20 seconds.
│ GB │ IE
■ 24
!
on the lid on the blender
in water or other
and the
! The blades are
.
. Ensure
in the lid fits cor-
.
into the built-in plug
repeatedly until the
starts to
7) Remove the power plug from the mains power
socket.
8) Remove any stubborn residue in the blender
jug or the blades
brush or a washing up sponge.
9) Afterwards, empty the blender jug
rinse it out thoroughly with clear water.
10) Wipe the exterior surfaces of the blender jug
with a moist cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance.
11) Wipe the lid
on
a damp cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water to
ensure that no detergent remains on the appli-
ance. Ensure that no moisture can get into the
contact plug on the lid on the blender jug
12) Wipe the mains cable with a damp cloth.
13) Dry all parts well before re-use.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.
and
using a washing up
, blades and sensor
SMK 1000 A1
and
with
!