Master Section - JB Systems PMD 8 Mode D'emploi

B. MASTER SECTION
1. BALANCED OUTPUT XLR CONNECTORS
PIN 1= GROUND (shield)
•
PIN 2 = HOT
•
PIN 3= COLD
•
2. UNBALANCED OUTPUT JACK CONNECTORS
Tip = signal +
3. MASTER LEVEL DISPLAY
It shows the output levels of the left and the right.
Make sure you don't exceed +3dB, this to avoid distortion.
4/5. STEREO GRAPHIC EQUALIZER
(4) Left stereo graphic equalizer.
Straight control of the balanced or unbalanced output.
(5) Right stereo graphic equalizer.
Same usage as Left graphic equalizer.
6. LEFT MASTER FADER
By adjusting the slider you control the mixed left output.
7. RIGHT MASTER FADER
By adjusting the slider you control the mixed right output.
8. DSP DIGITAL INDICATOR
Indicating the effect which the dsp is working at.
9/10. DSP PRESETS
(9) and (10) are up presets and down presets. When you choose
different presets, the correspondent number will change accordingly.
When you push the presets, the led is on but there is nog effect
output. Only when you push the enter key (13), there is
correspondent effect output and the led will stop flashing.
11. DSP SIGNAL INPUT LEVEL
It indicates the dsp signal input level. When the red led is on,
please make the input level a little less.
12. INTERNAL DSP
There are 32 effects you can choose from.
13. DSP ENTER
When you choose your presets, please push the key and than the
dsp is at the effect status that you choose.
PMD8 – PMD12
Ring = ground Sleeve = ground (shield)
3