Technical Data - Pfaff PROLINE Mode D'emploi

Hydraulic Dent Removal Tool
English

Technical data

Article number
Max. force
Cylinder stroke
Case dimensions L x W x H
Case features
Spreader
Spreading width
Suitable for ambient temperature
Operating pressure
Pump oil capacity
Cylinder oil capacity
Delivery rate per pump movement
Connection thread
Weight incl. case
Operating instructions
Use the pipe line (3) to connect the cylinder (1) to the
pump unit (2). To do so, screw the one end of the
pipe directly into the pump and join the coupling at
the other end to the coupling on the cylinder.
Make sure that all the parts are tightly screwed
before you start pumping!
To build up pressure in the hydraulic system, close the vent plug on the
pump by turning clockwise; if you now move the pump lever, the
pressure cylinder will be extended.
To depressurise the system, carefully turn the vent plug anti-clockwise.
The speed of depressurisation can be controlled by gentle turning of the
vent plug. Never depressurise abruptly!
The pump is best used in horizontal position. If used in other positions,
make sure that the pipes point down in order to prevent air being pump
with the fluid.
ð Protect the piston thread from damage (guard ring and cap).
ð Fit dust caps after disconnecting the high-pressure couplings from
the cylinder and the pipe.
Lateral loading of the piston is prohibited.
design changes under reserve
Max. spreading force
Min/max.
F 6.8.29
2453 025
kN 40
mm 127
mm 590 x 325 x 175
plastic
kN 5
mm 17,2 / 108
-10°C up to +40°C
bar 650
cm³ 440
cm³ 90
cm³ 1,9
NPF ¼" - 18
kg 20,5
2457 050
100
152
800 x 300 x 170
plastic
5
16,3 / 125,3
650
760
250
1,75
NPF ¼" - 18
34,5
vent plug
page 7