Publicité
Les langues disponibles
Les langues disponibles
EN
6
TRANSPORTATION, STORAGE AND DISPOSAL
6.1
TRANSPORTATION
• Any removable (electronic) parts, such as the charger and battery, should always be disconnected before
transport.
• Avoid transporting the product in bad weather conditions when possible.
• Make sure to adequately cover any exposed electronic parts if transportation in adverse weather conditions is
unavoidable.
• Use tape on open contacts of the battery and ensure it is securely stowed to prevent movement.
• High speeds, along with wind, and rain may force moisture into the electronic components, which can lead to
temporary malfunctions or permanent defects.
• In case of malfunction occurring after transport in such conditions, remove the battery and allow all parts to air-dry
when you reach your destination.
6.2
PUT THE PRODUCT IN TRANSPORTATION MODE
1.
Rotate the blower tube until it points up.
2.
Secure the hook strap from the blower tube to the hook strap receiving ring.
6.3
STORAGE
If the product is left unused for an extended period, proper storage maintenance is required.
• Store the product locked up to prevent unauthorized use or damage.
• Store the product in a dry, well-ventilated area.
• Store the product out of the reach of children.
6.4
DISPOSAL OF THE BATTERY, BATTERY CHARGER, AND PRODUCT
Symbols on the product or the package of the product mean that the product is not domestic waste. Recycle it at
a recycling station for electrical and electronic equipment. This helps to prevent damage to the environment and
persons.
Get in touch with your local authorities, domestic waste service, or your dealer for more information about how to
recycle your product.
7
TROUBLESHOOTING
PROBLEM
The product
does not start.
POSSIBLE
POSSIBLE
CAUSE
SOLUTION
Make sure that
The battery is
you securely in-
not installed
set the battery
tightly.
in the product.
The battery is
Charge the bat-
out of power.
tery.
Replace the de-
The switch is
fective parts
defective.
through an au-
English
PROBLEM
The air does
not flow
through the
tube when you
start the prod-
uct.
14
POSSIBLE
POSSIBLE
CAUSE
SOLUTION
thorized service
The motor is de-
center.
fective.
The PCB board
is defective.
The air inlet or
Carefully re-
tube outlet has a
move the block-
blockage.
age.
Publicité
