Facnor SD Série Notice De Montage page 13

B- FITTING OF THE HALYARD DEFLECTOR WHEEL:
 Slide the halyard deflector onto the forestay.
 Fit the two red bearings* (dwg. A) onto the wire with
their flat side opposite the screw (dwg. B) as shown on
the drawing. Then, insert the two red bearings fully into
the halyard deflector.
(* bearings are split to allow them to be placed around the
head stay below terminal end fitting).
 Secure with screw (dwg. B).
C- FITTING OF THE TOP CAP:
 Slide the top cap onto the forestay.
 Place two bearings onto forestay and slide on top
section. (Note that this section has a stop (dwg. D)
inside for the two bearings.)
 To fix the cap to the top section, tap with a soft head
hammer the pin (dwg. E).
Note : the cap and the single pin are in the carton.
Installation manual – SD headsail furler – page 2