Publicité
Les langues disponibles
Les langues disponibles
• Always show consideration for other people!
• Only use the product on appropriate surfaces,
which are level, clean and dry. Keep away
from other traffic users, if possible. Avoid
sloping terrain, stairs and open water.
• Never drive in the dark or when visibility is
poor.
• The brake gets hot if used continuously.
To avoid getting burned, do not touch it
before it has cooled down.
• Do not let your child use the product unsu-
pervised, as children cannot assess potential
dangers.
Preventing damage to the product!
• Avoid water, oil, potholes and very rough
surfaces.
Assembly
The product is supplied folded up in transport
condition. Proceed as follows to get it ready for
riding:
Unfolding (Fig. A)
1. Pull the safety lever (1) upwards and hold it.
2. Pull the lever (2) upwards, then release the
safety lever and fold the steering column (3)
forwards until it locks into place.
Mounting the grips (Fig. B)
1. Remove the grips (4) from the brackets (5).
2. Lift the cover flap (6).
3. Press the locking knobs (7) down on the grips
and push the grips on both sides into the
T-tube (8) of the steering column. The locking
knobs must snap audibly into place into the
holes (9) provided.
4. Press the cover flap down over the locking
knobs.
18
GB
Note: Tighten the retaining screws on
the cover flap regularly.
Adjusting the height of the steering
column (Fig. C)
The steering column can be adjusted to four
different heights. The product may only be used
if the locking knob is locked in place into one of
the four holes provided and the steering column
is then secured with the quick release fastener!
1. Loosen the quick release (10) on the steering
column (3).
2. Pull the steering column upwards, until the
locking knob (11) locks into place in one of
the four holes (12).
3. Secure the steering column by locking the
quick release.
Note: If the quick release does not fit snugly on
the steering column when tightening, tighten the
knurled screw firmly with the enclosed Allen key.
Make sure that the quick release fastener is
secured before tightening.
Steering head bearing (Fig. F)
The steering head bearing (18) is pre-set when
the product is supplied. If, after a while, the
handlebars have too much play or become too
stiff, get the steering head bearing adjusted by a
specialist dealer or at a bicycle shop.
Putting the product into trans-
port condition
1. Loosen the quick release (10) on the steering
column (3) and press the locking knob (11)
(Fig. C).
2. Push the steering column (3) all the way down
and lock the quick release (10) (Fig. C).
3. Lift the cover flap (6) (Fig. B).
4. Press the locking knobs (7) of the grips and
pull the grips (4) out of the T-tube (8) (Fig. B).
Publicité
