SilverCrest SLSN 3 D3 Mode D'emploi page 15

•
Slide the ON/OFF switch (7) towards the shaving foil (2) while the travel
safety lock (8) is pressed. The lady shaver will now start.
•
Hold the lady shaver so that the
trimmer (3) is facing the skin and
is angled at approximately 45°.
Now run the trimmer (3) along
the area of skin you are
trimming. Ideally, it is best to trim
against the direction of hair
growth.
•
Once you have finished trimming the desired area of skin, push the
ON/OFF switch (7) back into its original position. The lady shaver will
now stop.
•
We recommend cleaning the lady shaver with the cleaning brush (14)
after every shave. For details on how to clean the lady shaver more
thoroughly, please refer to section '9. Cleaning/maintenance'.
8.4 Cutter attachment (12)
The cutter attachment (12) should be used if you just want to shorten hair or
trim the bikini line.
•
Pull the protective cover (1) upwards.
•
Place the cutter attachment (12) onto the lady shaver from the top and
push it downwards until you hear it click into place. When putting on the
attachment, ensure that the recess for the trimmer locking mechanism (4) is
on the right-hand side.
•
Slide the ON/OFF switch (7) towards the shaving foil (2) while the travel
safety lock (8) is pressed. The lady shaver will now start.
•
Run the lady shaver in straight lines over the area of the hair you wish to
trim. Keep repositioning the lady shaver, moving it slowly against the
direction of hair growth.
SilverCrest SLSN 3 D3
English – 13