FLORABEST 332809 1907 Notice De Montage page 10

Congratulations!
You have chosen to purchase a
high-quality product. Familiarise
yourself with the product before
using it for the first time.
Read the following as-
sembly instructions and
the safety information
carefully.
Use the product only as described
and only for the given areas of
application. Store these assembly
instructions carefully. When pass-
ing the product on to third parties,
please also hand over all accompa-
nying documents.
Package contents
(Fig. A)
1 x upper post with hand crank (1)
1 x upper post without hand crank (2)
2 x lower post (3)
2 x drop arm (4)
2 x drive shaft (5)/(6)
2 x front bar (7)/(8)
1 x plastic piping (9)
1 x awning cloth (10)
4 x plastic cap (11)
2 x ceiling bracket (12)
2 x floor bracket (13)
2 x lock nut (14)
8 x dowel Ø 10/50 (15)
8 x screw ST6 x 50mm (16)
4 x screw M6 x 45mm (17)
4 x nut (18)
4 x plastic cap nut (19)
18 GB/IE
16 x washer M6 (20)
4 x screw ST3.5 x 9.5mm (21)
6 x screw ST3 x 9.5mm (22)
4 x washer M4 (23)
2 x knurled screw (24)
1 x tie rod (25)
1 x assembly instructions
Technical data
Dimensions:
approx. 200 x 225-275cm (W x H)
Radius of drop arms: max. 150cm
The product corresponds to wind
resistance class 0 (wind speed
< 20km/h).
The product must not be used in
wind speeds greater than 20km/h
for safety reasons!
Date of manufacture
(month/year): 01/2020
Intended use
The product is a sun shade designed
for outdoor use, such as on balco-
nies or terraces, and manufactured
for private use.
The product is not intended for com-
mercial use.
Safety information
Life-threatening
hazard!
• Never leave children unattended
with the packaging materials.
There is a risk of suffocation.
• The product is not a toy or a climb-
ing apparatus!
Ensure that persons, especially
children, do not pull themselves up
on the product or stand on it. The
product can tip over.
• The maximum load of the retract-
able parts of the awning must not
exceed 15kg!
• Check the product for damage or
wear before each use.
• Ensure that the plastic caps have
no external damage. Defective
plastic caps must be replaced.
• When installing on balconies or in-
stallation sites not on even ground,
the floor and ceiling brackets must
be fastened with suitable mounting
materials in order to prevent the
product from falling.
• Because of the risk of falling, make
sure that the person installing the
product is sufficiently secured with
a harness.
Risk of injury!
• Mind your fingers in particular
when retracting and extending the
product. There is a risk of injury
from crushing.
• The product may only be used
under adult supervision and must
not be used as a toy.
• Ensure the product is properly
stabilised before using it.
• Keep open flames, barbecues,
and patio heaters away from the
product.
• Check that all parts have been prop-
erly assembled before each use.
• Improper installation can impair the
product's safety and functionality.
• The product must not be used in
adverse weather conditions such
as strong winds, rain or snow.
• Retract the product if wind speeds
higher than 20km/h are expected
(strong breeze, larger branches
and trees move, and the wind is
clearly audible).
• Never use the product as shelter
during storms.
• Close the product if the wind picks
up or in other adverse weather
conditions.
• Before opening or closing the
product, ensure that there are no
persons or objects in the opening
or closing areas.
• The product offers protection from
direct sunlight outdoors. Due to
reflecting UV radiation, appropri-
ate sunscreen products should still
be used.
• Place the product on a flat, level
surface.
• Check the product for damage
or wear before each use. Check
regularly to make sure all screws
are tight! Only use the product if it
is in perfect condition!
GB/IE 19