Publicité
Les langues disponibles
Les langues disponibles
EN
5.
Securely tighten the screw with the hex wrench.
Note: When properly assembled, the upper and lower
shaft should not separate when pulled.
CAREFULLY FOLLOW THE ASSEMBLY
INSTRUCTIONS AS DESCRIBED ABOVE.
FAILURE TO DO SO MAY LEAD TO THE
PRODUCT SEPARATING, WHICH INCREASES
THE RISK OF PERSONAL INJURY.
4.3
INSTALL THE AUXILIARY HANDLE
1.
Attach the auxiliary handle on the shaft.
2.
Place the lower clamp into the slot on the
auxiliary handle.
3.
Install the screw and the knob. Do not fully
tighten.
WARNING
English
4.
Adjust the auxiliary handle to desired position.
5.
Securely tighten the wing bolt.
5
OPERATION
This section describes how to operate the product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
5.1
BEFORE YOU USE THE PRODUCT
5.1.1
CONNECT THE BATTERY CHARGER
Connect the battery charger to the proper voltage and
frequency that is specified on the rating plate.
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
5.1.2
CHARGE THE BATTERY
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
5.1.3
BATTERY INFORMATION
Refer to the Battery Operator Manual for information
about how to use the battery.
5.1.4
CONNECT THE BATTERY TO THE
PRODUCT
ONLY USE THE ORIGINAL BATTERY WITH THE
PRODUCT.
1.
Make sure that the battery is fully charged.
2.
Push the battery into the battery compartment.
The battery locks into position when you hear a
click.
8
WARNING
WARNING
Publicité
