Connection; Disconnecting; Select Charging Mode; Reset / Deleting Settings - ULTIMATE SPEED ULG 3.8 A1 Instructions D'utilisation Et Consignes De Sécurité

ProPErTy! DANGEr oF iNJUry! Ensure
that you do not strike electrical cables, gas or
water pipes when you are drilling into the wall.
If necessary, check the wall using a suitable
detector before you drill.
Y ou may find it convenient to attach the battery
charger on to a board or a wall. Screw the two
screws through the mounting holes
board or wall.

connection

Q
B efore starting the charging or discharging
procedure on a permanently installed battery
in a vehicle, first disconnect the minus pole con-
necting cable (black) of the vehicle from the
minus pole of the battery. The minus pole of the
battery is usually connected to the car body.
T hen disconect the plus pole connecting cable
(red) of the vehicle from the plus pole of the
battery.
F irst attach the „+" quick-release clamp (red)
of the battery charger to the „+" terminal of the
battery (see Fig. C).
A ttach the „–" quick-release clamp (black)
of the battery charger to the „–" terminal of
the battery (see Fig. C).
C onnect the mains lead
charger to an electrical power outlet socket.

Disconnecting

Q
D isconnect the appliance from the power supply.
D etach the „–" quick-release clamp (black)
from the „–" terminal of the battery.
D etach the „+" quick-release clamp (red)
from the „+" terminal of the battery.
R econnect the plus pole connecting cable of
the vehicle to the plus pole of the battery.
R econnect the minus pole connecting cable of
the vehicle to the minus pole of the battery.
into the
12
15
16
of the battery
11
16
15

Select charging mode

Q
You can select different charging modes for charging
different batteries at different ambient temperatures.
In comparison with conventional battery charging
stations, this appliance has a special function for
reusing an empty battery or rechargeable battery.
You can recharge an empty battery / rechargeable
battery. Safe charging is ensured by means of a
protection function against incorrect connection and
short circuiting. Due to the installed electronics, the
charging station does not begin operation directly
after connecting the battery, but only starts after a
charging mode has been selected.
This avoids sparking, which often occurs when
connecting. The battery charger is controlled by an
internal MCU (Micro-Computer Unit).

reset / deleting settings

Q
After connection to the power supply, the appliance
automatically returns to its basic setting and remains
in STANDBY mode
Switching between modes 1,
Q
2, 3 and 4
P ress the MODE selection button
priate number of times.
The device switches between charging modes in
the following order: Standby , MODE 1
„6 V", MODE 2 , MODE 3
and then repeats the cycle
NoTE: If a 12 V battery is connected, MODE 1 "6 V"
cannot be selected. If a 6 V battery is connected,
MODES 2, 3 and 4 "12 V" cannot be selected.
NoTE: If you press the selector button
mode automatically switches over to the next mode
and begins operation in that mode.
NoTE: However, if a battery is not disconnected
from the charging station after a full charge, the
Operation
the appro-
9
, MODE 4
, charging
9
GB 45