Publicité
Les langues disponibles
Les langues disponibles
Wheels wear out. This wear depends on many
factors, for example, the terrain, the size and
weight of the user, the weather conditions, the
material of the wheels and their hardness. It is
therefore necessary to replace them regularly.
1. Loosen the axle bolts (19)/(20) with two size
5 hex keys.
2. Pull out the axle bolts and remove the wheel.
3. Install the new wheel (15) and secure it with
the axle bolts.
After replacing the wheels:
Do not use the wheel if it pulls sideways after
installing it!
After the first few minutes of skating, make sure
that all screws are still tight and that nothing has
detached or become loose.
Tension the wheel once more to make sure that
it is running quietly and that the bearings are not
making any noise.
Replacing the ball bearings (Fig. G)
1. Remove the wheels (15) as described in the
section 'Replacing the wheels'.
2. Use a hex key to lever out a bearing (17).
3. Remove the spacer (18) from the wheel and
turn it over.
4. Lever out the other bearing with a hex key.
5. Insert a new bearing. Turn the wheel over,
insert the spacer, and then push in a second
new bearing.
6. Secure the wheel again as described in the
section 'Replacing the wheels'.
Storage, cleaning
We recommend that you clean and dry the
product thoroughly after use.
Remove small stones or other objects that may
have got caught on the wheels. Dry wet or
damp ball bearings with a clean cloth. Grease
the bearings with a suitable bearing lubricant
from the outside to prevent external rust. Always
store the product in a dry place.
Disposal
Dispose of the product and packaging
materials in accordance with current
local regulations. Store the packaging
materials (foil bags, for example) out of
the reach of children. For further information
about disposal of the product no longer needed,
contact your local council. Dispose of the
product and the packaging in an environmental-
ly friendly manner.
The Recycling Code distinguishes
different materials to be returned for
recycling. The Code consists of the
recycling symbol for the recycling process and a
number that identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under continuous quality control. DELTA-SPORT
HANDELSKONTOR GmbH gives private end
customers a three-year guarantee on this product
from the date of purchase (guarantee period)
in accordance with the following provisions.
The guarantee is only valid for material and
manufacturing defects. The guarantee does not
cover parts subject to normal wear and tear that
are thus considered wear parts (e.g. batteries)
or fragile parts such as switches, rechargeable
batteries, or parts made of glass.
Claims under this guarantee are excluded if the
product has been used incorrectly, improperly,
or contrary to the intended purpose, or if the
provisions in the instructions for use were not
observed, unless the end customer proves that
a material or manufacturing defect exists that
was not caused by one of the aforementioned
circumstances.
Claims under the guarantee can only be made
within the guarantee period by presenting the
original sales receipt. Please therefore keep the
original sales receipt. The guarantee period is
not extended by any repairs carried out under
the guarantee, under statutory guarantees, or
as a gesture of goodwill. This also applies to
replaced and repaired parts.
GB
19
Publicité
