Publicité
Les langues disponibles
Les langues disponibles
Model assembly
Cowl installation
1.Install the cowling to the front of the fuselage,
ensuring that the cowling is installed in the correct
direction.
Rear fuselage with vector tail nozzle installation (purchased separately)
1.Open the accessory package and take out the extension wires as needed (if the number of receiver
channels is insufficient, the package also includes two Y-harnesses for modelers to use). Connect the vector
servo wires to the extension wires, then align front and rear fuselage as shown.
2.Use the attached screws (HKM3.0*10mm x 1,HKM3.0*16 x 3) to secure the front and rear fuselage in
place.
3.Open the accessory package and take out the counterweight and screw. Push the counterweight into the
deepest position of the nose, then secure it in place using the provided screw (KA2*8).
HKM3.0*16mm
KA2*8mm
7
HKM3.0*10mm
HKM3.0*16mm
HKM3.0*16mm
E
N
Publicité
