Publicité
Les langues disponibles
Les langues disponibles
Installation
INSTALLING THE EMBER BEDS
You will need one phillips head screwdriver and remove the 3 ember beds from the carton to complete the
following instructions:
1. Remove the 2 screws on the left and right sides of the firebox that hold the glass front in place. Carefully
remove the glass front.
2. Arrange the ember beds (acrylic crystals or log set) along the inset window ledge at the front of the
electric firebox
3. Replace the glass front. Line up the holes on the front with the holes on the firebox and insert and tighten 2
screws to hold the glass front in place.
1.
MANTEL INSTALLATION
1. Place the assembled mantel near a 15-amp, 120-volt grounded electric outlet.
2. Place the insert directly in front of the mantel opening.
3. Carefully lift the insert through the center opening in the front of the fireplace. The bottom of the insert has
two foam rubber strips to prevent scratching of the hearth base. Slide the insert back through the opening
until the metal trim makes contact with the front of the mantel.
4. Install the mounting brackets provided with the insert in the pre-drilled holes on the bottom of the insert
(see Figure 2).
5. Carefully position mantel with installed fireplace against wall.
6. Plug the power cord into the 15-amp, 120-volt outlet.
CAUTION: Make sure that the unit is installed so that the power cord is not compressed against or caught on the
unit or the mantel and that it has an unobstructed path to the grounded outlet.
Figure 2.
2.
B or C
3.
BB
AA
7
Publicité
