Publicité
Les langues disponibles
Les langues disponibles
Operation (continued)
4. TEMPERATURE ADJUSTMENT BUTTON
This button displays F(Fahrenheit) or C(Celsius) depending on how the temperature mode is set.
When the temperature unit is set as 'F", the temperature scope is as follows:
"F" =Fahrenheit temperature 86°F, 84°F, 82°F, 80°F, 78°F, 76°F, 74°F, 72°F, 70°F, 68°F, 66°F, 64°F, 62°F.
"C" =Celsius temperature 30°C, 29°C, 28°C, 27°C, 26°C, 25°C, 24°C, 23°C, 22°C, 21.C, 20°C, 19°C, 18°C, 17°C.
5. TIMER BUTTON
This button controls the timer ON/OFF and 8-time setting from 1H to 8H. When the Timer is first turned on,
it will come on at the shortest time setting (1H). Each time the Timer button is pressed, the time increases
1 hour, up to the longest setting (8 hours). Once the set time expires, all fireplace functions will be
automatically turned off.
6. EMBER BED COLOR
Pressing the ember bed control button once lights the ember bed. Continue to press the ember bed
control button to cycle through different colors of the ember bed.
E1 :Orange E2 :Blue E3: Orange mixed with Blue E4: equals to 3 colors,E1,E2,E3 will cycle each 5 seconds.
7. FLAME COLOR
Pressing the flame control button once turns flames on.
Continue to press the flame control button to cycle
through different colors of the flame. Reference the table
for more information.
8. FAHRENHEIT/CELSIUS DISPLAY
This button displays F (Fahrenheit) or C (Celsius) depending on how the temperature mode is set. When the
fireplace is first turned on, the Fahrenheit (F) temperature will be displayed. To switch from Fahrenheit to Celsius,
or vise-versa, when HEATER is ON, hold HEATER CONTROL button for 10 seconds. The fireplace will remember
the last temperature mode setting, and in later use, the display will start at that setting, unless power to the unit
has been interrupted.
9. TEMPERATURE/TIMER DISPLAY
This LED display shows the set point for the temperature and timer functions. When either of these functions is
activated, the display reflects the set point for five seconds and then fades to black. Any change in the set
point of the temperature or timer will reactivate the display, which again fades after five seconds.
HEATER LOCKING FUNCTION
when fireplace is ON, press POWER button for 10 seconds, the HEATER will be locked and the HEATER button on
control panel as well as on remote control will be disabled, the purpose of this design is to avoid any mistake
that consumer turns on heater on summer, and before the heater being locked, the logset LED will flash 6
times. To un-lock the heater, that needs to press power button for 10 seconds, and before the heater un-
locked the logset LED will flash for 6 times
BUTTON PRESS
FLAME COLOR
1
Orange
2
Blue
3
Orange & Blue
4
Color Rotation
DISPLAY
A1
A2
A3
A4
9
Publicité
