ESX HXE110.2 Mode D'emploi page 11

FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Power-/Protection-LED
(2) Highpass/Bandpass filter controller
(3) Selector HP (High Pass) – FULL – LP/BP (Low Pass / Band Pass)
(4) Lowpass/Bandpass filter controller
(5) Audio signal outputs to supply additional amplifiers
(6) Audio signal inputs
(7) Bass Boost controller
(8) Input level controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the headunit or the electrical antenna
(7) Fuse(s)
2-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the headunit to drive 2 loudspeakers, in
stereo connect the following setup:
(1) To the headunit, line output right
(2) To the headunit, line output left
(3) Loudspeaker left
(4) Loudspeaker right
1-CHANNEL OPERATION MONO (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the headunit to drive a subwoofer, connect
the following setup:
(1) To the headunit, line output rear right or subwoofer output
(2) To the headunit, line output rear left or subwoofer output
(3) Subwoofer
IMPORTANT!
Always observe the correct polarity of all connections!
11