bosal 19-12C Mode D'emploi page 19

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
Remove the bumper and its inset (it will not be reinstalled later).
–
Insert accessory plates 2 and 3 into the chassis beam and according to drawing loosely
–
screw them at „a" positions with the attached bonding units.
Loosely screw drag hook body (1) to accessory plates at „b" positions with the attached
–
bonding units.
Adjust the drag hook into mid-position then tighten all the bearing bolts.
–
Cut off the bumper with the attached gauge.
–
According to requirements carry out connecting of electric wires breaking the rear sheaf of
–
cables.
Reinstall the bumper.
–
Installation of drag hook can exclusively be carried out by specialized car shop.
–
19