Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Check the fuel by a visual check , remove the fuel tank cap and reviewing the fuel level.
3.
Because of fuel expands, please fill the tank to the neck of tank only.
4.
Turn the fuel tank cap clockwise to assembly it in position.
Starting the engine
WARNING!
The cutting attachment may start to move when the engine is started. Make sure the
attachment cann ot come into contact with any object.
Make sure that no unauthorized persons are in the working area, otherwise there is a risk
of serious personal injury.
1.
Turn the engine switch to the" ON "position.
2.
Press the intake pump several times until fuel begins to fill the bulb(Fig.E-1)
3.
To start a cold engine, move the choke lever to the close position.(Fig.E-2), In order to
restart a warm engine, leave the choke lever in the "Open" position.
4.
Slowly pull the recoil starter until you feel it engage and then pull it quickly. Return
the recoil starter gently and slowly to the original position by hand.
Note: when the engine is started for the first time. It will require a number of
attempts to start until the fuel has travelled from the tank to the motor.
5.
Turn the choke lever to the OPEN position as the engine started. Pressing the throttle
trigger lockout and the throttle trigger, the choke lever will be into "Open" position itself.
6.
After starting the engine, let the engine run for 2 to 3 minutes so that it warms up before
subjecting it to any load.
Under the following conditions the machine must be stop:
When the motor rotary speed changes
-
When sparks occur
-
When bump head are damaged
-
In case of misfire
-
In case of high vibration
-
When flames or smoke appear
-
In rain or stormy weather
-
WARNING!
Check the cutting attachment always stops when the engine is idling.
Fitting of shoulder strap
1.
Put the strap link up with machine shown in (F-1).
2.
Adjust the perfect working and cutting position by using the various strap adjusters on the
carrying strap (F-2).
3.
In order to set the optimum length of the carrying strap, the user should then make a test
without starting the engine.
Important:
27
Publicité
Table des Matières
