Parkside PWS 125 D3 Traduction Des Instructions D'origine page 6

GB IE NI
The vibration values represent maximum valu-
es which have been determined with the sup-
plied blade. The actual vibration values may
vary depending on the used accessories.
The vibration values are still affected by the
handling for the user's.
Cutting disc (included):
Idling speed n ............. max.12200 min
0
Disc speed ....................... max. 80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22,23 mm
Thickness ................................... 3 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
Levels of noise and vibration were determi-
ned according to the norms and regulations
in the declaration of conformity.
The vibration emission value has been mea-
sured according to a standardised testing
method and may be used for comparison
with another electric tool.
The indicated vibration emission value may
also be used for an introductory assessment
of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool may
vary from the given values indepen-
dently of the type and way in which
the electric tool is used.
Safety measures for the protection of
the operator are to be determined
that are based on an estimate of the
actual exposure under the real ope-
rating conditions (for this, all parts of
the operating cycle are to be taken
into account, for example, times in
which the electric tool is turned off,
and those during which it is turned
on but running without a load).
6
Notes on safety
Caution! When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and fi re.
Please read all these instructions be-
fore using this electric tool and please
keep the safety instructions.
-1
Symbols and icons
Symbols on the device:
Warning!
Risk of injury from the rotating tool!
Keep hands away.
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!
Wear ear protection
Wear eye protection
Wear breathing protection
Risk of cuts!
Wear cut-resistant gloves.
Safety class II
Electrical machines do not belong
with domestic waste.
Other symbols on the
cutting disc:
Do not use for side grinding