Furrion Greystone GGR17D3MA1B-BL Manuel D'instructions page 23

PROBLEM/SYMPTOM
Area surface burners will not
ignite or area surface burners fully rotated to the LIGHT position.
do not ignite uniformly
Surface burner flame is
yellow or orange instead
of blue
Rev.4.26.24
Product Troubleshooting
POSSIBLE CAUSE/SOLUTION
Surface control knob has not been
Check to see if gas valve is open.
If not, open it.
Burners are clogged. Make sure
burner is off. Use a small wire,
toothbrush or needle to clean
burner ports and slots.
Low gas level in tank. Refill or replace
gas tank.
Hold burner knob in for at least 5
seconds once the burner is lit.
There is moisture on the burner. With
burner off, dry burner throughly.
Debris may be present in gas line. Let
burner run for a few minutes to see if
flame changes to blue.
Humid air in the home, sometimes
caused by running a humidifier, may
cause flames to be burn yellow.
23 CCD-0008338