Saba CT4654NFDKE Mode D'emploi page 38

You need the following tools to reverse the door:
8mm nut driver
1. Make sure that your refrigerator is unplugge.
2. Remove one screw in the hinge cover, remove hinge cover
and screws,then remove the hinge.
GB
3. Remove the freezer compartment door from the cabinet
4. Remove the two screws that secure the center hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge to the rig side
of the cabinet, then remove the hinge�
68
Phillips screwdriver
7� � Remove the washer and nut that secure the pin shaft to
the right hole on the lower hinge, then remove the shaft
。
已
。
8� � Insert the pin shaft into the left hole on the lower hinge,
then secure the shaft with the washer and nut�
Pin shaft
Pin scre w
Washer—@
Nu t—— 冬 酚
9� � Install the lower hinge on the left side of the cabinet.
Pin shaft
仁
Pin screw
霆—Washer
•
。
。 已
。
►
｀
＼
GB
69