Publicité
Les langues disponibles
Les langues disponibles
Cooktop Installation
Once the cabinet has been prepared according to the presented
dimensions and the gas line is in place.
1.
Unpack the cooktop, and lift it away from the packaging.
Remove all packing materials.
2. Lift the top glass
cover assembly at the rear side, push it
back and then pull to remove it.(Fig.1)(Fig.2)
Fig. 1
Fig. 2
3. Slide the cooktop into the cabinet opening. Verify that the
cooktop is level from side to side and front to rear (Fig.3).
Fig. 3
4. Attach the cooktop into the cabinet on both the left and
right sides using four self-tapping screws on both left and
right (2 screws each side).(Fig.4)
Fig. 4
Furrion
Gas Connection
1.
Connect a certified gas supply line with a 3/8" Flare
Female connection to the cooktop. Tighten according to
appropriate RV and gas codes using two wrenches. Hold
regulator in place while tightening gas connection. (Fig 5)
Fig. 5
IMPORTANT: Leave adequate space around the gas supply pipe
in case of bend or damage during installation. Make sure the gas
supply pipe is not contacting any moving parts after installed. Be
sure all openings in the cabinet around the gas line are sealed at
time of installation.
2. Check the pipe fittings for leaks using a soapy water
solution. See "Leak Check" section.(Fig.6)
Fig. 6
Pressure Check
1.
Turn LP gas off to the appliance.
2. Remove the Screw with the sealing gasket from the
pressure test port on the range.(Fig.7)
Fig. 7
- 5 -
CCD-0006069 Rev: 12-04-23
Publicité
